General Guides

P.I.D. Auto Tune Guide
What is P.I.D. Tuning? PID (Proportional Integral Derivative) is the system the printers use for holding a set temperature. This system controls how fast t...
Wed, Dec 12, 2018 at 1:08 PM
Integrating a Keenovo silicone heater into an EZABL system
This is a community member article, his contact info is at the bottom of this page. This is provided AS-IS and there is no support or warranty given from TH...
Wed, Dec 12, 2018 at 1:13 PM
Dual Extrusion Setup Information
When doing dual extrusion there are many way to go about it. The basic requirements are that you have a board that supports 2 Extruder connections, 2 hotend...
Sun, Feb 17, 2019 at 7:31 PM
Creality CR-10 and CR-10S Models – What Printer do you have?
Please make sure you know what printer you have. There are 8 DIFFERENT models from Creality. There are 2 different boards across these models. The easiest w...
Wed, Dec 12, 2018 at 1:21 PM
Arduino IDE for Mac OS X Setup Guide
Downloads All files are in the TH3D Unified Firmware or you can download just the TH3D Ardunio IDE Installer here: https://www.th3dstudio.com/downloads/TH...
Wed, Dec 12, 2018 at 1:25 PM